|•||Improved GPS Speed & Accuracy|
|•||Direct ECU Data Logging|
|•||User Selectable Backlight Colour|
|•||Inbuilt Track Database|
|•||Predictive Lap Timing|
|•||Integrated Wi-Fi Connectivity|
The AIM Solo 2 DL raises the bar for GPS lap timers. Like its predecessor, the unit is capable of being connected to the vehicles ECU in order to obtain various data from the sensors fitted to the car. A comprehensive range of compatible ECUs allows for an easy installation. However, if your particular ECU protocol is not supported, an ECU Driver Builder is available in the included Race Studio 3 Software.
The GPS technology used in this unit has been updated from its predecessor and now receives the data from two satellite constellations, GPS and Glonass; making for a significant improvement in data speed and positioning precision.This means that the start up time is reduced to a matter of seconds and lap times are accurate to a tolerance of two hundredths of a second.
The display of the Solo 2 DL features a selection of 7 different backlight colours which can selected by the user to suit their requirements. A sharp, high contrast display helps the driver to easily identify the data being displayed.
Making use of GPS technology, the Solo 2 DL is pre-loaded with a database of over 3,000 tracks from all over the world so that as soon as the unit is switched on, it identifies its position and loads the start line coordinates ready to begin recording lap times. If, however, the particular track that you are at is not recognised, the Solo 2 DL automatically enters autolearning mode and begins to build the track layout based on your car position and records the lap times.
The improved GPS technology in the Solo 2 DL also provides better reliability from the predictive lap timing function so that you can see, in real time, how your current lap compares to your best lap. The LEDs are also configurable to give a visual indication on whether you are quicker or slower. The Solo 2 DL now features a theoretical lap timing mode which pieces together your overall best sector times to provide an optimal lap time that could be achieved. Timing information can also be shown in a delta format which gives a representation of how much time you are quicker or slower than your best lap.
The Solo 2 DL is not just restricted to circuit racing, it can also be used for point to point or regularity events as well as performance tests such as 0-60 mph etc. As with the circuit racing mode, all data is recorded and can be reviewed immediately after the session.
This DL version has additional inputs via the vehicles OBDII port or through a CAN/RS232 connection, to enable data to be taken from the vehicles ECU. Sampled data depends on the actual ECU but typically includes RPM, engine load, throttle position (TPS), oil / air / water temperature, oil pressure, battery voltage, speed, gear, lambda value (air / fuel ratio). The list of available ECU drivers, constantly updated and upgraded, is published here: it includes approximately 1000 different ECUs, either stock or racing. They are sorted by manufacturer/vehicle model: for each ECU you will find the proprietary communication protocols, including the standard OBDII ones.
New for the Solo 2 DL is a coil RPM input which provides a digital input derived from either square wave signals (8-50 V each signal) or pulse signals (150-450 V ignition coil trigger – primary circuit)
Connecting the Solo 2 DL to your ECU (standard or racing ECU) is very simple. To choose which connection you need to order (CAN or OBDII / K-Line), use the above link to see what ECU connection is used for your application.
If you want to further review the data at greater length, the Solo 2 DL has integrated Wi-Fi so that you can transfer data securely and quickly to a laptop or computer up to 50m away without the need for connectors or cables. You can then import the data into the AIM Race Studio 3 software for full analysis.
Dimensions: 98 x 73.7 x 30.2mm